This study examines the fatigue life of S275 mild steel at room temperature. Mechanical components can fail under cyclic loading during period of time, known as the fatigue phenomenon. In order to prevent fatigue induced failures, material behavior should be investigated to determine the endurance limit of the material for safe design and infinite life, thus leading to reducing the economic cost and loss in human lives. The fatigue behavior of S275 mild steel was studied and investigated. Specimens were prepared in accordance with ASTM E3-11, and fatigue tests of the specimen were conducted in accordance with ASTM E466-07 on a smooth plate, with a continuous radius between ends (hourglass-shaped plate). The method of fatigue testing was applied with constant load amplitude and constant frequency of 4 Hz with load ratio (Fully Reversal R= -1). Surface fractures of specimens were investigated using Scanning Electron Microscope (SEM). The experimental results were compared with the results of a Finite Element Analysis (FEA), using simulation software. The experiment results indicated that the endurance fatigue limit of S275 mild steel was 195.47 MPa.
 Callister WD, “Materials Science and Engineering: An Introduction”, 2nd edn. New York: John Wiley & Sons Inc, 1991.
 Shigley, Joseph E., Charles R. Mischke, and Richard G. Budynas. “Mechanical engineering design”. McGraw-Hill, 2011.
 D. Hendrickson, “Fatigue failure due to variable loading, university of Michigan” – Flint.
 Jono, Masahiro. "Fatigue damage and crack growth under variable amplitude loading with reference to the counting methods of stress–strain ranges." International Journal of Fatigue 27.8 (2005): 1006-1015.
 Y. Weing: Int J. Fat. Vol 15 (1993), p 243.
 Basquin OH, “The exponential law of endurance test”. Pro ASTM,1910, 10:625-630.
 American Society for Testing and Materials. Committee E08 on Fatigue and Fracture, “Standard practice for conducting force controlled constant amplitude axial fatigue tests of metallic materials”. ASTM. 2007.
 ASTM American Society for Testing and Materials, “Standard test methods for tension testing of metallic materials”. ASTM international. 2009.
 EN-10025-2 OR BS EN 10204.
 Standard, A.S.T.M., E3-11, “Standard Guide for Preparation of Metallographic Specimens”, ASTM International, West Conshohocken, PA, DOI: 10.1520/E0003-11. 2011.
 Mohammad, Khairul Azhar, et al. "Fatigue Life for Type 316L Stainless Steel under Cyclic Loading." Advanced Materials Research. Vol. 701. Trans Tech Publications, 2013.
 Callister, W. D. and Rethwisch, D. G. “Materials science and engineering” (Vol. 5, pp. 344-348). NY: John Wiley & Sons. 2011.
 Vassilopoulos, Anastasios, ed. Fatigue life prediction of composites and composite structures. Elsevier, 2010.
 Campbell, J. D. and Duby, J. “The yield behavior of mild steel in dynamic compression”. Proc. R. Soc. Lond. A, 236.1204 (1956): 24-40.
 Proulx, T., Conference Proceedings of the Society for Experimental Mechanics Series.
 Theocaris, P. S. "Yield criteria based on void coalescence mechanisms." International journal of solids and structures22.4 (1986): 445-466.
 Fischmeister, H. E. L. L. M. U. T. F., et al. "Modelling fracture processes in metals and composite materials." Z. Metallkd.80.12 (1989): 839-846.
 Thomas, Daniel J. "Using Finite Element Analysis to Assess and Prevent the Failure of Safety Critical Structures." (2017): 1-3.