Excellence in Research and Innovation for Humanity

International Science Index


Select areas to restrict search in scientific publication database:
10008635
Design and Validation of an Aerodynamic Model of the Cessna Citation X Horizontal Stabilizer Using both OpenVSP and Digital Datcom
Abstract:
This research is the part of a major project at the Research Laboratory in Active Controls, Avionics and Aeroservoelasticity (LARCASE) aiming to improve a Cessna Citation X aircraft cruise performance with an application of the morphing wing technology on its horizontal tail. However, the horizontal stabilizer of the Cessna Citation X turns around its span axis with an angle between -8 and 2 degrees. Within this range, the horizontal stabilizer generates certainly some unwanted drag. To cancel this drag, the LARCASE proposes to trim the aircraft with a horizontal stabilizer equipped by a morphing wing technology. This technology aims to optimize aerodynamic performances by changing the conventional horizontal tail shape during the flight. As a consequence, this technology will be able to generate enough lift on the horizontal tail to balance the aircraft without an unwanted drag generation. To conduct this project, an accurate aerodynamic model of the horizontal tail is firstly required. This aerodynamic model will finally allow precise comparison between a conventional horizontal tail and a morphed horizontal tail results. This paper presents how this aerodynamic model was designed. In this way, it shows how the 2D geometry of the horizontal tail was collected and how the unknown airfoil’s shape of the horizontal tail has been recovered. Finally, the complete horizontal tail airfoil shape was found and a comparison between aerodynamic polar of the real horizontal tail and the horizontal tail found in this paper shows a maximum difference of 0.04 on the lift or the drag coefficient which is very good. Aerodynamic polar data of the aircraft horizontal tail are obtained from the CAE Inc. level D research aircraft flight simulator of the Cessna Citation X.
Digital Article Identifier (DAI):

References:

[1] B. Howard. (2016). MIT's Ultra-Light Composite Morphing Aircraft Wing Harkens Back to the Wright Brothers (ExtremeTech ed.). Available: https://www.extremetech.com/extreme/238954-mits-ultra-light-composite-morphing-aircraft-wing-harks-back-wright-brothers
[2] S. Barbarino, O. Bilgen, R. M. Ajaj, M. I. Friswell, and D. J. Inman, "A review of morphing aircraft," Journal of Intelligent Material Systems and Structures, vol. 22, pp. 823-877, 2011.
[3] A. D. Finistauri, "Conceptual Design of a Modular Morphing Wing," Bachelor of Engineering, Ryerson University, 2005.
[4] O. S. Gabor, A. Koreanschi, and R. M. Botez, "Optimization of an Unmanned Aerial System'wing using a Flexible Skin Morphing Wing," SAE International Journal of Aerospace, vol. 6, pp. 115-121, 2013.
[5] O. Ş. Gabor, A. Koreaschi, R. M. Botez, M. Mamou, and Y. Mebarki, "Analysis of the Aerodynamic Performance of a Morphing Wing-Tip Demonstrator Using a Novel Nonlinear Vortex Lattice Method," 2016.
[6] T. Grigorie, R. Botez, and A. Popov, "Design and Experimental Validation of a Control System for a Morphing Wing," in AIAA Atmospheric Flight Mechanics Conference, 2012.
[7] A. Koreanschi, O. Sugar-Gabor, and R. Botez, "Drag Optimisation of a Wing Equipped with a Morphing Upper Surface," The Aeronautical Journal, vol. 120, pp. 473-493, 2016.
[8] S. G. Olivu, "Validation of morphing wing methodologies on an unmanned aerial system and a wind tunnel technology demonstrator," Ecolde de technologie superieur, 2015.
[9] O. Sugar Gabor, A. Simon, A. Koreanschi, and R. M. Botez, "Application of a Morphing Wing Technology on Hydra Technologies Unmanned Aerial System UAS-S4," in The ASME 2014 International Mechanical Engineering Congress & Exposition, Montreal, Que., Canada, 2014.
[10] B. Iannotta, "Features-Vortex Draws Flight Research Forward-Following a Lead Aircraft at just the Right Location in its Vortex may Prove a Feasible way to Fly Further and Save Fuel," Aerospace America, vol. 40, pp. 26-32, 2002.
[11] I. Secretariat, "Aviation’s Contribution to Climate Change," BAN Ki-Moon, 2010.
[12] G. Ghazi, "Développement d'une plateforme de simulation et d'un pilote automatique-application aux Cessna Citation X et Hawker 800XP," Master University of Quebec-École Polytechnique de Montréal, 2014.
[13] G. Ghazi, M. Bosne, Q. Sammartano, and R. M. Botez, "Cessna citation X stall characteristics identification from flight data using neural networks," in AIAA Atmospheric Flight Mechanics Conference, 2017, p. 0937.
[14] G. Ghazi and R. Botez, "Development of a high-fidelity simulation model for a research environment," SAE Technical Paper 0148-7191, 2015.
[15] G. Ghazi, R. Botez, and J. M. Achigui, "Cessna citation X engine model identification from flight tests," SAE International Journal of Aerospace, vol. 8, pp. 203-213, 2015.
[16] G. Ghazi, R. M. Botez, and M. Tudor, "Performance database creation for cessna citation x aircraft in climb regime using an aero-propulsive model developed from flight tests," AHS Sustainability, 2015.
[17] G. Ghazi, A. Mennequin, and R. M. Botez, "Method to Calculate Aircraft Climb and Cruise Trajectory using an Aero-Propulsive Model," in AIAA Atmospheric Flight Mechanics Conference, 2017, p. 3550.
[18] G. Ghazi, M. Tudor, and R. Botez, "Identification of a Cessna Citation X aero-propulsive model in climb regime from flight tests," in International Conference on Air Transport INAIR, 2015.
[19] R. S. Félix Patrón, Y. Berrou, and R. M. Botez, "Climb, Cruise and Descent 3D Trajectory Optimization Algorithm for a Flight Management System," in Aviation Technology, Integration, and Operations, 2014.
[20] R. S. Félix Patrón and R. M. Botez, "Flight trajectory optimization through genetic algorithms coupling vertical and lateral profiles," in ASME 2014 International Mechanical Engineering Congress and Exposition, 2014, pp. V001T01A048-V001T01A048.
[21] R. S. Félix Patrón, A. Kessaci, R. M. Botez, and D. Labour, "Flight trajectories optimization under the influence of winds using genetic algorithms," in AIAA Guidance, Navigation, and Control (GNC) Conference, 2013.
[22] A. Murrieta-Mendoza, J. Gagné, and R. M. Botez, "New search space reduction algorithm for vertical reference trajectory optimization," INCAS Bulletin, vol. 8, p. 77, 2016.
[23] A. Hamy, A. Murrieta-Mendoza, and R. Botez, "Flight Trajectory Optimization to Reduce Fuel Burn and Polluting Emissions using a Eerformance Eatabase and Ant Colony Optimization Algorithm," 2016.
[24] A. Murrieta-Mendoza, H. Ruiz, S. Kessaci, and R. M. Botez, "3D Reference Trajectory Optimization Using Particle Swarm Optimization," in 17th AIAA Aviation Technology, Integration, and Operations Conference, 2017, p. 3435.
[25] P.-A. Bardela and R. M. Botez, "Identification and Validation of the Cessna Citation X Business Aircraft Engine Component Level Modeling with Flight Tests," 2017.
[26] P.-A. Bardela, R. M. Botez, and P. Pageaud, "Cessna Citation X Engine Model Experimental Validation."
[27] T. Rogalsky and R. Derksen, "Bézier–PARSEC Parameterization for Airfoil Optimization," Canadian Aeronautics and Space Journal, vol. 55, pp. 163-174, 2009.
[28] R. Derksen and T. Rogalsky, "Bezier-PARSEC: An Optimized Aerofoil Parameterization for Design," Advances in Engineering Software, vol. 41, pp. 923-930, 2010.
[29] R. A. McDonald, "Interactive Reconstruction of 3D Models in the OpenVSP Parametric Geometry Tool," in 53rd AIAA Aerospace Sciences Meeting, American Institute of Aeronautics and Astronautics, Kissimmee, FL, 2015, pp. 1-10.
[30] J. Byrne, P. Cardiff, and A. Brabazon, "Evolving Parametric Aircraft Models for Design Exploration and Optimisation," Neurocomputing, vol. 142, pp. 39-47, 2014.
[31] J. E. Williams and S. R. Vukelich, "The USAF Stability and Control Digital Datcom. Volume I. User’s Manual," McDonnell Douglas Astronautics co St Louis mo1979.
Vol:12 No:10 2018Vol:12 No:09 2018Vol:12 No:08 2018Vol:12 No:07 2018Vol:12 No:06 2018Vol:12 No:05 2018Vol:12 No:04 2018Vol:12 No:03 2018Vol:12 No:02 2018Vol:12 No:01 2018
Vol:11 No:12 2017Vol:11 No:11 2017Vol:11 No:10 2017Vol:11 No:09 2017Vol:11 No:08 2017Vol:11 No:07 2017Vol:11 No:06 2017Vol:11 No:05 2017Vol:11 No:04 2017Vol:11 No:03 2017Vol:11 No:02 2017Vol:11 No:01 2017
Vol:10 No:12 2016Vol:10 No:11 2016Vol:10 No:10 2016Vol:10 No:09 2016Vol:10 No:08 2016Vol:10 No:07 2016Vol:10 No:06 2016Vol:10 No:05 2016Vol:10 No:04 2016Vol:10 No:03 2016Vol:10 No:02 2016Vol:10 No:01 2016
Vol:9 No:12 2015Vol:9 No:11 2015Vol:9 No:10 2015Vol:9 No:09 2015Vol:9 No:08 2015Vol:9 No:07 2015Vol:9 No:06 2015Vol:9 No:05 2015Vol:9 No:04 2015Vol:9 No:03 2015Vol:9 No:02 2015Vol:9 No:01 2015
Vol:8 No:12 2014Vol:8 No:11 2014Vol:8 No:10 2014Vol:8 No:09 2014Vol:8 No:08 2014Vol:8 No:07 2014Vol:8 No:06 2014Vol:8 No:05 2014Vol:8 No:04 2014Vol:8 No:03 2014Vol:8 No:02 2014Vol:8 No:01 2014
Vol:7 No:12 2013Vol:7 No:11 2013Vol:7 No:10 2013Vol:7 No:09 2013Vol:7 No:08 2013Vol:7 No:07 2013Vol:7 No:06 2013Vol:7 No:05 2013Vol:7 No:04 2013Vol:7 No:03 2013Vol:7 No:02 2013Vol:7 No:01 2013
Vol:6 No:12 2012Vol:6 No:11 2012Vol:6 No:10 2012Vol:6 No:09 2012Vol:6 No:08 2012Vol:6 No:07 2012Vol:6 No:06 2012Vol:6 No:05 2012Vol:6 No:04 2012Vol:6 No:03 2012Vol:6 No:02 2012Vol:6 No:01 2012
Vol:5 No:12 2011Vol:5 No:11 2011Vol:5 No:10 2011Vol:5 No:09 2011Vol:5 No:08 2011Vol:5 No:07 2011Vol:5 No:06 2011Vol:5 No:05 2011Vol:5 No:04 2011Vol:5 No:03 2011Vol:5 No:02 2011Vol:5 No:01 2011
Vol:4 No:12 2010Vol:4 No:11 2010Vol:4 No:10 2010Vol:4 No:09 2010Vol:4 No:08 2010Vol:4 No:07 2010Vol:4 No:06 2010Vol:4 No:05 2010Vol:4 No:04 2010Vol:4 No:03 2010Vol:4 No:02 2010Vol:4 No:01 2010
Vol:3 No:12 2009Vol:3 No:11 2009Vol:3 No:10 2009Vol:3 No:09 2009Vol:3 No:08 2009Vol:3 No:07 2009Vol:3 No:06 2009Vol:3 No:05 2009Vol:3 No:04 2009Vol:3 No:03 2009Vol:3 No:02 2009Vol:3 No:01 2009
Vol:2 No:12 2008Vol:2 No:11 2008Vol:2 No:10 2008Vol:2 No:09 2008Vol:2 No:08 2008Vol:2 No:07 2008Vol:2 No:06 2008Vol:2 No:05 2008Vol:2 No:04 2008Vol:2 No:03 2008Vol:2 No:02 2008Vol:2 No:01 2008
Vol:1 No:12 2007Vol:1 No:11 2007Vol:1 No:10 2007Vol:1 No:09 2007Vol:1 No:08 2007Vol:1 No:07 2007Vol:1 No:06 2007Vol:1 No:05 2007Vol:1 No:04 2007Vol:1 No:03 2007Vol:1 No:02 2007Vol:1 No:01 2007